New in 2007!

Single-sided edgebander with pre-mill
Coil feed with turntable and manual strap feed
Adjustable alignment with digital read-out
1st Station: Pre-mill/jointing/trimming with
(2) milling heads, each has a 2.2kw (3 HP), 400V, 3Ø, 12,000 RPM
Motor granular hot melt glue
Magazine feed designed to handle material up to 65 mm in height
Edging thickness of 3 mm x 45 mm in height and .8mm x 65 mm in height – pneumatically adjustable
Turntable will handle coils up to 800 mm in diameter
Machine has capacity to handle edging straps manually from .4 mm to 8 mm in thickness
Pneumatic guillotine for coil cut-off (roll cutting unit)
(3) roll pressure section with (1) driven 5” diameter & (2) 3” diameter idler rollers – digital readout
2nd Station: Front and rear cut-off/trim
Train motor .18kw (1/4HP), 400V, 3Ø, 12,000 RPM
3rd Station: top and bottom, trimming units
Trimming motors (2) .55kw (3/4 HP), 400V, 3Ø, 12,000 RPM
Digital readouts
4th Station: Top and bottom fine trim/routing units
Tilting, Capable of straight (flush), chamfered or radius trimming
Digital readout
Trim motor .55kw (3/4HP), 400V, 3Ø, 12,000 RPM
5th Station: Profile trimming unit
Chamfer and profile the corners
Profile motor .35kw (1/2HP), 400V, 3Ø, 11,000 RPM
Digital readout
6th station: Top and bottom scraping units
Mechanical with pneumatic movement and digital readout
7th Station: Top and bottom buffing units
Buffing motors (2) .21kw (1/3HP), 230/400V, 3Øm, 1450 RPM
Variable feed system with rubber padded feed chain & top mounted beam with rubberized rollers
Feed motor 1.5Kw (2HP), 230/400V, 3Ø
Brandt PC-20 controller (post mounted-swivel)
Alpha-numeric keypad with graphic monitor
All functions are controlled from screen
Adjustments for temperature, feed speed and all stations
Adjustable out-board panel support
Includes dust manifold to where it meets the spread pipe on dust collector