Ask Seller 
Finance
Pinske Edge "5200" Drawer Notcher & Drill 
Active
Complete Shop Closure - El Cajon, CA
El Cajon, CA
- Current Price : $500.00 USD ( ) No Reserve
- 1 Bid(s)
- High Bidder: N****n
The Drawer Depot - Complete Plant Closure - El Cajon, CA ( Active #68502521 )
Complete plant closure featuring, Schelling FH6630 Beam Saw, Weeke BHX 055 Vertical Machining Center, Homag ABD260 Drill and Dowel Machine, Kentwood R340E-MI Gang Rip Saw, Kentwood Moulder, Mereen Johnson 1101-A Dovetail Machine, Omec F11TS Dovetail Machine, DMC 30RCS110 Wide Belt Sander Plus much more!
-
Item Location
El Cajon, CA
-
Make
Pinske Edge
-
Model
"5200"
-
Serial Number
040207123
-
Year
-
Phase
3 PHASE
-
Voltage
220 VOLT
-
Inspection Date
See Homepage page for inspection dates
-
Final Removal Date
See Homepage page for removal datess
-
Estimated Dimensions
49" x 36" x 45"
-
Estimated Weight
1,000 Lbs
-
Seller Comment
A non-negotionable loading fee has been established. This includes loading onto a flat bed trailer.
-
Load Fee
75.00
-
Lot Notes
-
page views
36
Pinske Edge "5200" Drawer Notcher & Drill
The Pinske Edge Drawer Notcher is designed to notch and drill your cabinet drawer boxes for undermount hardware quickly and easily – the process takes approximately 10 seconds per drawer!
Cut the notch and drill the hole by setting your drawer box over the cutter and activating the drill. By activating push buttons and stepping on a foot control, the cutter rises at the same time the drilling is taking place. There is a safety switch that will only allow this process to happen if the drawer box is properly located. A 3HP 3-Phase motor, available in 208-230 or 460 Voltage, operates at 3450 RPM and rotates the cutter at 4000 RPM. A totally enclosed motor is standard. The speed at which the cutter is raised can be adjusted to suit your requirements. The rest of the machine is pneumatic driven. The hardware mounting hole is drilled with a hi-speed air drill with a solid carbide (.250″) drill bit that was specifically designed for drilling wood. It requires 80 PSI and dust requirement of 430 SCFM. This machine is also set up to accept 4″ diameter dust collection.
32" x 48" Table, Back fence, Foot pedal operation
The listed specifications & information were taken from the manufacturer’s published information, internet research, or seller’s description.
The specifications & information are assumed to be correct; however, in no way, guaranteed. Bidders are encouraged to inspect the machine, call with questions, or contact the manufacturer for more information.
Please log in to view the bid history
LoginNo information available