Ask Seller
Biesse "Lato 38" Edgebander 
Ended
Biesse "Lato 38" Edgebander - Palm City, FL
- Winning Bid : $5,101.00 USD Sold
- 9 Bid(s)
- High Bidder: n****e
Biesse "Lato 38" Edgebander - Palm City, FL ( Closed #45786940 )
Custom woodworking company in South Florida is updating their shop and auctioning a Biesse edgebander no longer required for continuing operations.
-
Item Location
3520 SW Armellini Ave., Bay H Palm City, FL 34990
-
Make
Biesse
-
Model
Lato 38
-
Serial Number
68917
-
Year
2006
-
Phase
3 PHASE
-
Voltage
230 VOLT
-
Inspection Date
By appointment only, contact Jack Ragan, [email protected], 503-806-4611
-
Final Removal Date
March 7 - March 17, 2023 (by appointment)
-
Estimated Dimensions
168" L x 48" W x 50" H
-
Estimated Weight
2,750 Pounds
-
Seller Comment
Seller will disconnect and load onto buyer's flatbed truck/trailer for non-negotiable $200 loading fee. Palletizing, crating or other services may be available at an additional cost.
-
Load Fee
200
-
page views
1224
Biesse "Lato 38" Edgebander
See video of machine in operation
- min. panel width: 85 mm or 50 mm w/ 250 mm panel length
- min. panel length: 140 mm
- max. panel thickness: 45 mm
- 8 mm capacity for strip edgebanding
- Siemens controller with soft keys
- Edgebanding infeed table
- Auto strip and coil feed magazine with 3 mm PVC guillotine
- Teflon coated hot melt glue pot
- Dual digital thermostats
- 1 in. diameter glue applicator roller
- Pressure section w/ (1) large diameter non-stick coated drive roller
- Two (2) pneumatic pressure controlled idle rollers
- Two (2) motor end trimming station
- .5 HP motors
- Motors travel on 45 degree slides and tilt 0-12 degrees on a horizontal plane
- Top and bottom rough trimming station
- .7 HP motors
- Motors tilt 0 -30 degrees
- Top and bottom fine trimming station trimming station
- .73 HP motors
- Motors tilt 0-30 degrees
- Digital readouts for setup (t and b w/ quick change motors for tool change)
- Top and bottom scraping station
- Pneumatic pressure control for scraping knives
- Digital readout for horizontal adjustments
- Top and bottom buffing station
- .5 HP motors
- Units tilt 0-30 degrees
- Top and bottom hot air station
- Feed chain with "anti-slip" 80 mm wide rubber pads
- Feed Speed: 33 FPM w/ 2 HP drive
- Sound enclosure
- Outboard roller support
Listed specifications were taken from manufacturer's published information and is assumed to be correct but not guaranteed. Bidder is encouraged to inspect the machine, call with questions or contact the manufacturer for more information.
Listed specifications were taken from the manufacturer’s published information and is assumed to be correct but not guaranteed.
Bidder is encouraged to inspect the machine, call with questions contact the manufacturer for more information.
Please log in to view the bid history
LoginNo information available