Homag "KL 79/A20/S2" Edgebander

• Capacity Specifications: 0.4 - 20 mm Edge thickness cap.,min. panel width 55 mm (2-3/16") for panel thickness12 - 22 mm (1/2" - 7/8") and under;


• 100 mm (3.9") for panel thickness over 22 - 60 mm (7/8" - 2- , -5/16"); for up to 3 mm Coil stock, HPL, and strip stock up to 20 mm (3/4").


• Top pressure beam with: Double-wide compound Vbelts;80 mm wide feed track chain plates, vulcanized rubber insert pads, and Auto-Lube; variable feed speed from 18 - 24 MPM (59 - 79 FPM); 950 mm height/working level infeed


• Pre-Milling Station with: (2) 3 kW - 150 Hz, 9,000 RPM Motors, panel blowoff device; 2-position infeed fence (on/off), SIKO digital manual fence control. Panel Pre-Heater with: Quartz lamp for heating substrate edge before glue application.


• Edge Feeding device equipped with: Automatic coil magazine for quick coil changeover; strip feeder for up to 20 mm (3/4") solid wood banding.


• "Quick Melt" Glue System with: Reversible glue roller applicator; pressure roll section with (1) large dia. driven and (6) idle rollers; manual adjustment of pressure zone through SIKO digital counters for different edge thicknesses.


• Double motor front & rear end trim, straight & chamfer trimming (0.8 HP - 12,000 RPM ea. motor).


• Top & Bottom flush trim (2 HP - 12,000 RPM ea. motor).


• Profile Trimming unit "FK13" to process overhanging edges and trimming around the leading & trailing edge (0.75 HP each motor), 8-position tool changer .


• Edge Scrape Super-Finishing unit for thick PVC/ABS with chip collection box.


• Top & Bottom Flat Glue Scraper to remove potential glue squeeze-out.


• Top & Bottom oscillating buffing unit (two 0.33 HP - 1,650 RPM motors).


• "HOMATIC NC 16" controller features with Keypad & LCD display, stores working programs and controls functions of workstations, allows fault diagnostic and more etc.


• Complete with: PLC controlled, motorized beam height adjustment; servo adjustments on Top & Bottom flush trim, and servo controlled Scraper Stations.


• Electronic DC brakes on all trim motors sound cabins for all trim workstations and adjustable outboard panel support.

RIG & LOAD FEE...$ 1,100.00

Listed specifications were taken from manufacturer's published information and is assumed to be correct but not guaranteed. Bidder is encouraged to inspect the machine, call with questions or contact the manufacturer for more information.