Vitap Eclipse automatic contour edge-banding with glue pot and trimming machine for big and small pieces includes:

Two (2) bags of Jowat glue included

Edgebanding station

    Glue and tape application on big and small shaped panels

    2.2 pound capacity glue pot

    Two (2) rollers to copy the shape of the piece

    Utilizes 2 x 800 heating elements with electronic temperaturecontrol via thermo regulator

    Glue application amount is adjusted via a knob

    Set up of the glue temperature

    Automatic guillotine for coiled material up to 3 mm x 45 mm

   Guillotine is activated by an electronic encoder for closed edged pieces for the joint of the extremities of the tape or byencoder when the piece has only one side contoured

   Manual feeder of the panel

   Raise-able working table for small panels

   Electronic counter for cutting off edgebanding

  On/off automatic feeder of the panel

  Two (2) rollers to copy the shape of the piece

Trimming station

     Trimming unit with two (2) motors 0.67 HP high frequency, 12,000 RPM with up/down/front copiers and pneumatic system to lift themotors approaching the pieces to be trimmed

   On/off trimming unit

   Two (2) brazed cutters R=3 bevel =15° D=69 (MIN. 60) Z=6

   Raise-able working table for small panels

   Turning table unit for large panels

   Holding arm with vacuum table to hold the big panels for edgingand trimming

   Dust extraction - 80 mm/3.15" port

   Inside minimum radius - 250 mm (as a general rule – application dependent)

   16 – 60 mm panel with 1 mm edge tape

   16 – 40 mm panel with 2 mm edge tape

   16 – 30 mm panel with 3 mm edge tape

   With 1 mm edge tape – the minimum outside radius is 30 mm (as a general rule)

   With 2 mm edge tape – the minimum outside radius is 50 mm (as a general rule)

   With 3 mm edge tape – the minimum outside radius is 80 mm (as a general rule)

   Height of tape = 18 mm/0.7" minimum to 64 mm/2.5" maximum