BIESSE POLYMAC MODEL #SINGLE 89 CONTOUR EDGEBANDER MACHINE

YEAR 2007 BUILT MACHINE

230 VOLT, 3-PHASE

**SPECS. AS PULLED FROM MANUFACTURER WEBSITE:

Standard Equipment for Single 89

·         Glue pot under table, 11 lb. capacity

·         Glue temperature control

·         Adjustable gates for glue amount

·         Automatic edge magazine for strips (maximum thickness: 5 mm) and rolls (maximum thickness: 3 mm)

·         Needle and rubber feed rollers

·         Cutting device for roll feed (3 mm capacity) 

·         Edge pressure device consisting of one power roller and two idler rollers 

·         Foot pedal with time delay

·         Large edge magazine for diameter 650/800 mm 

·         Work table will tilt 0 to 45 to band beveled edges

·         Electronic digital readout for tape length 

·         Outboard support with 360' rollers for straight or shaped panels

·         End Trimming (butting unit) for end trimming of panels.       

·         Working Panel thickness 120mm (E00051) 

Technical Data

·         Working thickness of panel        10 TO 120 mm (0.39” – 4.75”)

·         Banding material thickness         Rolls: .4 to 3 mm (.01" - .11")

                                                        Strips: up to 5 mm (.19")

·         Maximum diameter of rolls          800 mm (31.4")

·         Feed speed, variable                   4 to 18 m/mm (6.7' - 60')

·         Minimum inside radius                20 mm (3/4")

·         Minimum panel length                 300 mm (11")

·         Compressed air required              5 bar

·         Weight                                       770 lbs.

·         Operating voltage                        220v, 3ph, 60 cycles